Lab subscriptions are excluded from this change and will remain on the same renewal process as usual. 3Shape - Learn what license is needed for 3Shape software: Applies to: 3Shape: Solution: Software Licenses Needed for 3Shape Modules. However, if neither of these is of help to you and you are missing an entire section of margin maybe have the iTero scanner checked as to its speed and accuracy. Additional software includes Studio Apps such as TRIOS Design Studio, Splint Studio, Clear Aligner Studio, Implant Planner, Implant Studio, and Ortho software such as Ortho System, Model Builder, and Indirect Bonding. training your doctors is always better than fixing errors that should not exist in the first place. The design workflow mimics the manual steps for Removable Partial design thereby ensuring intuitive and accurate digital control over a technique-demanding process. depends how bad the holes are, or how severe the distortions get. 3Shape’s 3rd generation Removable Partial Design includes new and powerful tools for reliable creation of removable partials while reducing production time by 60-70. apart from setting the point spacer down to its lowest value, and going over the edge with a fine zoom, you arent going to get a properly set auto-margin, ever.Īs to holes in the margin, two options exist - sculpt-on-die to re-create the data and be somewhat confident in its accuracy, or rescan of the patient. iTero dies are incredibly hard to mark properly, and lose a TON of data when you Scan a model. Thanks for the compliment Kent, but this issue goes deeper than i can resolve.
0 Comments
Leave a Reply. |